Best Screwdriver for Switch Pro Controller (Y00 + #00)

The Nintendo Switch Pro Controller is the enthusiast alternative to Joy-Cons, and its repair picture is slightly different. It uses the same tri-wing Y00 case screws as a Joy-Con, plus Phillips #00 internal screws, and has a larger battery plus vibration motors that need a steadier hand during reassembly. Here's how the Fanttik E1 MAX fits.

The Quick Answer

Yes — the Fanttik E1 MAX is the right screwdriver for Nintendo Switch Pro Controller repair. Its 50-piece bit set includes tri-wing Y00 (for the case) and Phillips #00 (for internals), and the 0.05 Nm low torque plus 3 Nm manual mode cover the full disassembly and reseating workflow.

Why This Question Matters

Pro Controller repairs are increasingly common as the first generation of Switch owners hit the 3-5 year mark on their controllers. Stick drift, failed trigger buttons, and battery swelling are the big three. Each of these requires opening the case — which requires the tri-wing Y00 bit — and then dealing with Phillips internals. An electric driver with the right bit set and torque control turns each repair from an hour into 20 minutes.

The Specs You Need to Know

Step-by-Step: Pro Controller Stick Replacement

1. Charge the Pro Controller's battery to roughly 50% before starting, so if the battery needs swapping you have a visual reference.
2. Use the tri-wing Y00 bit and low torque to remove the 4 external case screws.
3. Carefully lift the back cover. Note the ribbon cable connecting the rumble motors — don't yank it.
4. Switch to Phillips #00 bit, keep low torque. Remove the internal frame screws, working symmetrically.
5. Lift the battery carefully (no metal tools against the battery). Set it aside on a non-conductive surface.
6. Access the stick modules. Unscrew the stick bracket screws, swap the stick module, reseat.
7. Reassemble in reverse order. For the final case closing with Y00 screws, you can use manual mode (3 Nm cap) to feel the screws seat without over-driving.

What to Watch Out For

• The Pro Controller's rumble motors are attached with adhesive and thin wires. Reassembly alignment matters — if the motors are even 1 mm off-center, the case won't close flat.
• Replacement analog sticks for the Pro Controller come in two flavors: genuine Nintendo-spec and Hall-effect. Hall-effect sticks don't have the drift-prone potentiometer issue but require a different calibration. Know before you buy.
• The battery is a single-cell lithium pouch. If it has any visible swelling, replace immediately — don't try to flatten it or continue to use it.

FAQ

Q: Does the Pro Controller use the same screws as a Joy-Con?
A: For the case screws, yes — both use tri-wing Y00. Internal screws differ: Pro Controller uses more Phillips #00, Joy-Con uses Phillips #000.

Q: Is the E1 MAX torque range safe for Pro Controller screws?
A: Yes. The 0.05 Nm low-torque mode is safe for every screw in the Pro Controller. The 3 Nm manual mode is reserved for final seating if any screw feels unusually tight.

Q: Can I fix Pro Controller drift with a Hall-effect stick upgrade using the E1 MAX?
A: Yes. The mechanical repair is identical; only the stick module is different. The E1 MAX handles all the screws involved.

Verdict

For Nintendo Switch Pro Controller repair, the Fanttik E1 MAX is the right electric screwdriver — with tri-wing Y00 for the case, Phillips #00 for internals, and the low-torque/manual torque settings that avoid stripping Nintendo's soft fasteners.

Related reading: Screwdriver for Switch Joy-Con · Screwdriver for PS5 disassembly · Screwdriver for iPhone repair