After a jump starter starts your car, plug it in and recharge it before you store it or count on it again. Use the charging method and accessories listed for your exact model. Then confirm it has reached the charge level the manufacturer specifies.

Don't rely on the battery reading you saw right after the jump. That number only shows the charge at that moment. It can't tell you whether a later recharge happened or finished.
How to Recharge It After a Jump Start
Charging inputs, approved chargers, and full-charge signals vary from model to model, so your model's instructions control the details. Here's the post-use routine:
- Find your model's instructions. Look for the model name on the unit's label. Then use the manual for that exact model, not for a similar one. Fanttik owners can find your model's manual in our support hub, which includes a T8 APEX support page and manual under Jump Starters.
- Charge with the documented input and accessories. Use the charger and cable the manual names for your model. A matching plug alone doesn't prove a charger is approved.
- Charge to the manufacturer's storage target. For the T8 APEX, our support guide says to charge it to 100% before storing it in the trunk.
- Confirm completion the way the manual defines it. Use the full-charge indicator or reading your manual describes. Don't assume the unit is full because a set amount of time has passed.
- Keep it topped up while stored. For trunk storage, our T8 APEX guide says to top it up to full every 90 days. It also says not to store the unit below 50% for more than one month.

A post-jump reading is not proof of a recharge
The T8 APEX screen displays the remaining battery level and the battery voltage in real time. That's useful for seeing where the unit stands, but a reading taken before you charge only describes that moment. You need a check after charging, using the full-charge signal your manual defines.
Listed recharge time is a reference, not a finish line
The T8 APEX has a 65W USB-C Power Delivery (PD) input, and its product listing gives a 1.5-hour full recharge. Treat that as a planning figure. When the time is up, check the unit itself to confirm it's done, using the method in your manual.
Cold storage is a separate issue from charging. If your car sits in freezing weather, our guide to jump starter storage in a frozen trunk covers how cold affects the battery and how to warm the unit up. If your household keeps a jump starter in several vehicles, it can help to sync charge cycles across vehicles so you don't miss a top-up.
FAQs
How long does the Fanttik T8 APEX take to recharge?
Our T8 APEX listing gives 1.5 hours for a full recharge through its 65W USB-C PD input. This figure applies only to the T8 APEX. Other jump starters charge at different rates, so use the time listed for your own model.
What does the T8 APEX screen show while charging?
The 3.0-inch screen shows remaining battery level and battery voltage in real time.
Can I use any USB-C PD charger with a jump starter?
A USB-C PD input label doesn't mean every USB-C charger or cable is approved for that unit. Use the charger and cable your model's instructions list. If you're unsure which accessories fit your Fanttik model, you can contact our support team with the model name.
Should I recharge even if the jump barely used any battery?
Yes, for the T8 APEX. Our guide says to charge it to 100% before trunk storage, whatever charge is left after the jump. Recharging right away also means you don't have to remember the last reading or guess how much charge is left.














































Leave a comment
This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.